CHPWS Red Dot Optic Adapter Plate - Walther Defense PDP 2.0 to Trijicon RMR / SRO / Holosun 407C / 507C / 507Comp / 508T / C&H EDC-XL / COMP

✨  CHPWS Red Dot Optic Adapter Plate  ✨

Walther Defense PDP 2.0 to Trijicon RMR / SRO / Holosun 407C / 507C / 507Comp / 508T / C&H EDC-XL / COMP

This plate is for the 2.0 cut from Walther and will not work with the 1.0.
Please reference the second photo to determine your cut before purchase.

The C&H Precision plates are designed, manufactured and shipped from their small family owned business in Coastal Georgia.  Each plate is precision machined to the tightest tolerances on HAAS CNC machines and each plate goes through multiple quality checks.

Compatible Firearms

• Walther DEFENSE PDP 2.0
• Walther PDP F Series
• Walther PDP Pro
• Walther PDP Steel Frame

Compatible Optics

• C&H COMP
• C&H EDC-XL
• Holosun 407C
• Holosun 507C
• Holosun 507Comp
• Holosun 508T
• Trijicon RMR
• Trijicon SRO

Specifications

• Material: Plates are made from 6061 aluminum. All mounting hardware is Stainless Steel
• Finish: Plates are MIL-SPEC Type III Hard Anodized – Black
• Replaceable 416 Stainless Steel T-Posts for maximum thread engagement

Included

• Qty 1 – Optic Plate
• Qty 3 – M3 x 6 MM FH Plate Mounting Screws
• Qty 3 – 4-40 x .320 FHB Trijicon RMR Optic Mounting Screws
• Qty 3 – 4-40 x .280 FHB Holosun 507C / 508T Mounting Screws
• Qty 3 – 4-40 x .345 FHB Trijicon SRO , CHPWS COMP /EDC XL Optic Mounting Screws
• Qty 3 – 4-40 x .250 FHB Optic Mounting Screws
• Qty 3 – Patented 416 Stainless Steel T-Nuts

Installation Instructions

DRY-FITTING DISCLAIMER:
C&H Precision products are designed and manufactured to meet tight tolerances. Installation can be affected by variations in your plate, hardware, optic, and firearm tolerances. For safe installation and to prevent potential damage to any component, C&H advises dry-fitting all parts before a full installation. If any problems arise during this process, please reach out to C&H Precision Customer Service.
­
IRON SIGHTS DISCLAIMER:
When making aftermarket firearm modifications, factory components can often become obsolete, particularly when mounting optics on the slide, whether through direct milling or using a plate. Achieving the correct height for low co-witness iron sights depends on factors such as the firearm type, mounting plate, optic, and slide cut. For assistance in determining the appropriate iron sight height for your specific setup, please contact C&H Precision Customer Service.