Product Overview
✨ CHPWS Red Dot Optic Adapter Plate ✨
Sig P226/P229 RX Series / Pro Series / AXG Scorpion w/ R1P / DPP CUT w/ RMR / Holosun Holes – Filler Plate for Trijicon RMR / SRO / RCR / Holosun 407C / 507C / 507Comp / 508T / C&H EDC-XL / COMP
**FOR TRIJICON RCR, READ DESCRIPTION BELOW**
THIS PLATE REQUIRES A ROMEO 1 PRO OPTIC READY CUT WITH RMR HOLES, REFER TO THE PICTURES TO VERIFY YOUR SLIDE HAS THE CORRECT HOLES AND CUT.
The C&H Precision plates are designed, manufactured and shipped from their small family owned business in Coastal Georgia. Each plate is precision machined to the tightest tolerances on HAAS CNC machines and each plate goes through multiple quality checks.
THIS PLATE REQUIRES A ROMEO 1 PRO OPTIC READY CUT WITH RMR HOLES, REFER TO THE PICTURES TO VERIFY YOUR SLIDE HAS THE CORRECT HOLES AND CUT.
This filler plate does not require any additional screws. It is held in place with the RDS and it’s mounting screws.
Specifications:
- Material: Plates are made from 6061 aluminum. All mounting hardware is Stainless Steel
- Finish: Plates are MIL-SPEC Type III Hard Anodized – Black
Included:
- Qty 1 – Optic Plate
- Qty 3 – 6-40 x .3125 M3H Holosun 507C / 508T Optic Mounting Screws
- Qty 3 – 6-40 x .380 M3H Trijicon RMR / SRO Optic Mounting Screws
- Qty 3 – 6-40 x .460 M3H CHPWS COMP / EDC XL Optic Mounting Screws
**Trijicon RCR**
The RCR Optic comes with Trijicon screws that are “Patented”. You must use the screws they provide you. C&H will not make new screws for this optic / plate combo. It is the responsibly of the consumer to check fitment of the provided screws for length. The screws may have to be slightly modified or shortened in order to ensure proper fitment.
DRY-FITTING DISCLAIMER:
C&H Precision products are designed and manufactured to meet tight tolerances. Installation can be affected by variations in your plate, hardware, optic, and firearm tolerances. For safe installation and to prevent potential damage to any component, C&H advises dry-fitting all parts before a full installation. If any problems arise during this process, please reach out to C&H Precision Customer Service.
IRON SIGHTS DISCLAIMER:
When making aftermarket firearm modifications, factory components can often become obsolete, particularly when mounting optics on the slide, whether through direct milling or using a plate. Achieving the correct height for low co-witness iron sights depends on factors such as the firearm type, mounting plate, optic, and slide cut. For assistance in determining the appropriate iron sight height for your specific setup, please contact C&H Precision Customer Service.
